{
    "default_filament_colour": [
        "#000000"
    ],
    "dont_slow_down_outer_wall": [
        "1"
    ],
    "enable_pressure_advance": [
        "1"
    ],
    "filament_cost": [
        "100"
    ],
    "filament_extruder_variant": [
        "Direct Drive Standard"
    ],
    "filament_flow_ratio": [
        "0.935"
    ],
    "filament_max_volumetric_speed": [
        "15"
    ],
    "filament_settings_id": [
        "PURE PETG"
    ],
    "filament_vendor": [
        "PUREFILAMENT"
    ],
    "from": "User",
    "idle_temperature": [
        "20"
    ],
    "inherits": "Generic PETG",
    "name": "PURE PETG",
    "nozzle_temperature_range_high": [
        "255"
    ],
    "nozzle_temperature_range_low": [
        "230"
    ],
    "pressure_advance": [
        "0.028"
    ],
    "reduce_fan_stop_start_freq": [
        "0"
    ],
    "slow_down_layer_time": [
        "1"
    ],
    "slow_down_min_speed": [
        "100"
    ],
    "textured_cool_plate_temp": [
        "70"
    ],
    "textured_cool_plate_temp_initial_layer": [
        "70"
    ],
    "version": "2.0.0.56"
}